Good News For Galaxy Note II mobile users, now they will update their device with the latest Android 4.3 Jelly bean N7100XXUEMJ5 Leaked firmware. This is the new test firmware which carries lots of new features like Samsung Knox and Samsung Wallet. Currently the Firmware is under development and more feature will add on the official update. Installing this new leaked Firmware will not increase your binary counter, so no need to worry about your phone warranty. Galaxy Note II is powered with Quad-core 1.6 GHz Cortex-A9, Super AMOLED capacitive touchscreen, 16M colors, 8 MP camera and 2 GB RAM.
If you are the owner of the Galaxy Note II device and want to try the new leaked firmware on your phone, then here is the complete guide which helps you to update your device with this new N7100XXUEMJ5 firmware. As we already mention above this is the test firmware and under development stage, So update is at your own risk and We won’t be liable if any damage occurs to your device and/or its components. But before following the guide do take the full backup of your device.
Table of Contents
Pre-requisites and Requirements
a) Before following the guide do take the Full Backup of your Android Apps, SMS, Contacts, Call Logs, Bookmarks. Looking for more ways to get the Backup your android device click here. So in case if you lost some of your important data and files in the update or rooting process, then you can easily restore them from your backup file. Read also how to take the backup of WhatsApp messages and restore it.
b) Once the backup files are saved on your device or on your desktop, Enable USB debugging mode on your device, read the guide here how to enable USB debugging mode.
c) Make sure that your Galaxy Note II battery is full charge or near about 60-70% battery level.
d) Download the Latest Samsung Galaxy Note 10.1 USB drivers on your PC and install it to start the update process. You need these drivers to connect your device with the computer to follow this guide.
After following the above mention steps follow the below mention guide one by one to update Galaxy Note II. All the above mention steps are very important, so do follow all the steps and do exactly what is told.
How to Install N7100XXUEMJ5 Android 4.3 Firmware on Galaxy Note II
Step 1. Download the N7100XXUEMJ5 Android 4.3 Firmware here on your desktop and Extract/Unzip the folder on your desktop.
Step 2. Download the latest ODIN tool from here to flash the firmware on your phone and extract the folder on your desktop.
Step 3. Now turn of your phone and reboot it into Download mode. To do this Press and hold Home + Power + Volume down buttons.
Step 4. Now connect your Phone to the computer with USB cable and run the ODIN application on your desktop.
Step 5. Now Load the firmware files (extracted in Step 1) in Odin as instructed below:
Add N7100XXUEMJ5_N7100OLBEMJ4_N7100XXUEMJ5_HOME.tar.md5 to AP
Next, ensure that the check boxes “Auto Reboot”, “F. Reset Time” and “PDA” are the only check boxes checked and the rest are not. And Make sure re-partition is NOT ticked on the ODIN application.
Step 6. Check all the setting again and Click start button, sit back and wait a few minutes.
Step 7. Now the update process will start on your device and this will take some time to finish.
Step 8. Once the updated process is finished on your device, your device will reboot and you will see the”PASS” message on your ODIN application screen, At this time you can disconnect your phone from the computer.
Now your Galaxy Note II is updated with the Android 4.3 jelly bean firmware. In case at the time of restart your device stuck on Android loop or stuck on Android boot screen, then follow this guide to come out of Android loop.